Vending motor dispenser X2 standard

Product dispenser for Vendig machines. Fits perfect to the Product Silo 9930500715

Operation:
1 On Self Hold
The grounded signal send to the pin 6 for a minimum of 0.5 seconds start dispensingen the product.
At the end of the operation X2 autonomously returns to its starting position, ready for the next dispensing.
2 Direct control (high side switch)
The signal sent to +12V to pin 1 starts dispensing the product.
Dispensing can be de-activated by exclusing the sending of this signal.
When the tape´s flap passes the sop switch it transforms it into a position sensor, leading to the shortcircuiting of pin 4.
To electronic manage the signal we suggest using a pull-up.
3 Direct control (Low side switch)
The ground signal sent to to pin 6 starts dispensing the product.
Dispensing can be de-activated by exclusing the sending of this signal.
When the tape´s flap passes the sop switch it transforms it into a position sensor, leading to the shortcircuiting of pin 4.
To electronic manage the signal we suggest using a pull-up.
At the end of the operation X2 autonomously returns to its starting position, ready for the next dispensing.At the end of the operation X2 autonomously returns to its starting position, ready for the next dispensing.
Function:
Coin is placed into the hole and transported with the slide to the coin validator.
This mechanism prevents the objects other than coins in the ball can be placed.
Applications:
Vending machines, change machines, parking meters, etc.
Technical data:
Dispensing speed (Standard mod.) 3.5seconds
Powersupply 12 Vdc +/- 10%
Weight (Standard mod.) 254 g

Conditions for use:
For the X2 motor dispenser to function propertly it should be installed inside machines to following conditions for use.
Not exposed to direct sunlight
Minimum temperature 0° C
Maximum temperature 50°C
Relative humidity between 50% and 90%
dimensions: W 54,5 mm x H 60 mm x D 147,3 mm
Weight: 254g